Search results for 'Typhoon 4in1 S Racer ESC 4x30A'

Speical designed FPV Camera, with WDR AV output for Video transmitter and record HD video(1080P 60FPS) on SD Card. 

Controller board using 30.5x30.5mm standard mounting holes, Lens/Sensor could be exchanged when defect. 

Wide angle (145degree) Lens and OV4689 1/3 CMOS Sensor（4M）incl. 

Learn More

A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode,  Supports 6x UART

Learn More

BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.

BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.

Learn More

The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.

Learn More

The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.

Learn More

4in1 ESC with 30.5x30.5 mm Mounting holes, supports DSHOT 1200, BLHELI32 firmware.

Learn More

Mr. Copper 2306 2700KV Motor Learn More

PDB with 4800uf Capacitors, improve ESC performance and cancelling Power Noise.Learn More

SH1.0 Cable Sets A Learn More