Search results for 'Cable sets for FC - SH1.0 type'

A new generation AIO Flight control for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode, 

Learn More

25x25mm Flight controller with 20x20 mm mounting holes.Learn More

OpenLager is a "better openlog":

It's faster-- 4 bit SD interface clocked at 19.2MHz with DMA.
It has buffer memory to ride out times when the SD card is busy-- 125kbytes in current firmware.
It fits in a smaller form factor.
ESD protection (series resistors) on input pins.
And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings.
OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to openlager's RX pin!

Learn More

MicroOSD v2.4 - AB7456 Version Learn More

4in1 ESC with 20x20 mm Mounting holes, supports DSHOT 1200, BLHELI32 firmware

Learn More

SH1.0 Cable Sets A Learn More

4in1 ESC with 30.5x30.5 mm Mounting holes, supports DSHOT 1200, BLHELI32 firmware.

Learn More

A new generation AIO Flight control for FPV, based on F405 MCU, using F405 MCU controls OSD over SPI bus in DMA mode, 

Learn More

BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.

BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.

Learn More