Search results for 'OMNIBUS AIO F3 PRO Flight Control'

Items 11 to 20 of 23 total

per page

Page:
  1. 1
  2. 2
  3. 3
  • OMNIBUS Fireworks v2

    The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.

    Learn More
    $49.99

  • Wraith32 Metal V2 - 32bit BLHELI ESC

    BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.

    BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.

    Learn More
    $34.99

  • Asgard32 F4 / F7

    Upgraded Asgard, incl.4x35A BLHELI32 ESC, supports ESC Telemetry function.

    Uses a new Betaflight target, utilising 6x UARTs.

    Learn More
    $99.99

  • OMNIBUS F4 Pro (V3)

    Upgrade version of OMNIBUS F4, the OMNIBUS F4 Pro (Some shop call it as OMNIBUS F4 PRO V2) added SD card supports, has 5v3A BEC, LC filter for Camera and VTX, build in Current sensor for high Integration Frame.

    Learn More
    $34.99

  • A2 Camera - FPV Camera with HD Recording

    Speical designed FPV Camera, with WDR AV output for Video transmitter and record HD video(1080P 60FPS) on SD Card. 

    Controller board using 30.5x30.5mm standard mounting holes, Lens/Sensor could be exchanged when defect. 

    Wide angle (145degree) Lens and OV4689 1/3 CMOS Sensor(4M)incl. 

    Learn More
    $79.99

  • 8x E1806 Motor 2300KV

    1806  Brushless motor for multicopter, 2300KV. 

    Learn More
    $50.00

  • OMNIBUS AIO F3 V2

    A new generation AIO Flight control for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode, 

    Learn More
    $29.99

  • Airbot F4 Nano v4 2-4s

    25x25mm Flight controller with 20x20 mm mounting holes.Learn More
    $24.99

  • OpenLager

    OpenLager is a "better openlog":

    It's faster-- 4 bit SD interface clocked at 19.2MHz with DMA.
    It has buffer memory to ride out times when the SD card is busy-- 125kbytes in current firmware.
    It fits in a smaller form factor.
    ESD protection (series resistors) on input pins.
    And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings.
    OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to openlager's RX pin!

    Learn More
    $19.99

  • MicroOSD v2.4 - AB7456 Version

    MicroOSD v2.4 - AB7456 Version Learn More
    $8.99

Items 11 to 20 of 23 total

per page

Page:
  1. 1
  2. 2
  3. 3