You have no items in your shopping cart.
Search results for 'sp racing'
A2 Camera - FPV Camera with HD Recording
Speical designed FPV Camera, with WDR AV output for Video transmitter and record HD video(1080P 60FPS) on SD Card.
Controller board using 30.5x30.5mm standard mounting holes, Lens/Sensor could be exchanged when defect.
Wide angle (145degree) Lens and OV4689 1/3 CMOS Sensor（4M）incl.
Learn More$79.99
OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
Learn More$42.99
Furling32 - 32bit BLHELI ESC
BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.
Learn More
BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.$14.99
OMNINXT F7
The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.
Learn More$59.99
OMNIBUS Fireworks v2
The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.
Learn More$49.99
Typhoon32 4in1 ESC 4x35A v2.1
4in1 ESC with 30.5x30.5 mm Mounting holes, supports DSHOT 1200, BLHELI32 firmware.
Learn More$59.99
Mr. Copper 2306 Motor
Mr. Copper 2306 2700KV Motor Learn More$19.99
MatrixPDB
PDB with 4800uf Capacitors, improve ESC performance and cancelling Power Noise.Learn More$19.99
Ori32 4in1 ESC 4x25A 2020
4in1 ESC with 20x20 mm Mounting holes, supports DSHOT 1200, BLHELI32 firmware
Learn More$44.99
OpenLager
OpenLager is a "better openlog":
It's faster-- 4 bit SD interface clocked at 19.2MHz with DMA.
Learn More
It has buffer memory to ride out times when the SD card is busy-- 125kbytes in current firmware.
It fits in a smaller form factor.
ESD protection (series resistors) on input pins.
And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings.
OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to openlager's RX pin!$19.99