Search results for 'f4 pro v3'

25x25mm Flight controller with 20x20 mm mounting holes.Learn More

OpenLager is a "better openlog":

It's faster-- 4 bit SD interface clocked at 19.2MHz with DMA.
It has buffer memory to ride out times when the SD card is busy-- 125kbytes in current firmware.
It fits in a smaller form factor.
ESD protection (series resistors) on input pins.
And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings.
OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to openlager's RX pin!

Learn More

PDB with 4800uf Capacitors, improve ESC performance and cancelling Power Noise.Learn More

The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.

Learn More

The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.

Learn More

BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.

BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.

Learn More