Search results for 'miniom osd'

6 Item(s)

per page

  • OpenLager

    OpenLager is a "better openlog":

    It's faster-- 4 bit SD interface clocked at 19.2MHz with DMA.
    It has buffer memory to ride out times when the SD card is busy-- 125kbytes in current firmware.
    It fits in a smaller form factor.
    ESD protection (series resistors) on input pins.
    And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings.
    OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to openlager's RX pin!

    Learn More
    $19.99

  • OMNIBUS Fireworks v2

    The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.

    Learn More
    $49.99

  • OMNINXT F7

    The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.

    Learn More
    $59.99

  • OMNIBUS AIO F4 V6 Flight Control - 5xUARTs

    OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.

    Learn More
    $34.99

  • OMNIBUS F4 Nano v7

    A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode,  Supports 6x UART

    Learn More
    $42.99

  • OMNINXT F7

    The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.

    Learn More
    $59.99

6 Item(s)

per page